Skip to content
Kovich & Savard Hardwood Flooring

specialty · Norfolk County, MA

Custom Staining
in Wrentham, Massachusetts.

The exact color you have in your head, on the floor. Serving Wrentham homeowners with three generations of family craftsmanship.

What this is

Generic stain colors miss. We mix custom stain blends on-site, lay sample panels directly on your sanded floor, and only proceed once you sign off in your own light, in your own room.

Custom Staining & Color Matching in Wrentham, Massachusetts starts at $1.75/sq ft* for labor,with material quoted separately and the final number set at a free in-home estimate. Kovich & Savard has been doing hardwood floor work in Norfolk County since 1928, three generations deep, owner-led, fully insured, and rated 5.0 across every verified review platform.

For Wrentham homes specifically: New construction colonials, larger square footage. That context matters, we don't approach a 1920s Wrentham colonial the same way we'd approach a 2010 build out toward Norfolk. The wood, subfloor, and adjacent finishes all tell us what to do.

The stain that looked perfect on a sample card at the hardware store almost never reads the same on a full floor under your home's daylight and lighting. We solve this with on-site stain panels: 3' x 3' swatches applied to your actual sanded floor, viewed at the same hour you'll see them every day.

Common requests we deliver: matching an inherited dining table, harmonizing with cherry kitchen cabinets, achieving a smoky 'limed' grey-brown, deepening red oak to read like walnut, or pulling a yellowed 1990s floor back to a modern neutral.

Our stains are oil-based for color depth and grain pop. We allow proper dwell time, wipe back excess, and seal with finish that won't yellow over the stain, a common failure mode of cheaper systems.

Why Wrentham homeowners choose us over a chain or a one-man crew: a chain dispatches whoever is closest and racks up their margin; a one-man crew can do beautiful work but disappears mid-project when their van breaks down. We're a two-owner shop with a trained crew, a permanent address in North Easton, and a 98-year track record in Norfolk County. The person who measures your floor is the person who runs the install, and they answer the phone five years later if you have a question.

From our base in North Easton to Wrentham is a short drive, well inside the radius where we can swing by for a free estimate within a few business days, then deliver the written proposal inside 48 hours of that visit. We are not padding your estimate with travel time, dispatch fees, or a "minimum job" charge that pushes small repairs into rooms you didn't need redone.

98+

Years of experience

500+

MA homes served

5.0

Star rating

Regularly

In Wrentham

What you get

Why Wrentham homeowners hire us for custom staining.

On-site sample panels, signed off before commitment

You see the actual color on your actual floor before we go room-wide. No surprises.

Custom blends, not just catalog colors

We mix two-part and three-part stains to land an exact tone. Bring us a swatch, an Instagram screenshot, or a single chair leg.

Matched to your finish system

We pair stain chemistry with the right top coat so your color reads true for decades, not months.

Process

How custom staining works in Wrentham.

  1. 01

    Discovery

    Bring color references, physical samples, photos, paint chips. We talk grain, sheen, and lighting.

  2. 02

    Sand to bare wood

    Stain only takes properly to clean, freshly sanded wood.

  3. 03

    Panel out 3, 5 options

    We lay multiple panels directly on your floor in the actual room.

  4. 04

    Live with it 24 hours

    You see panels in morning light, midday, and evening light before deciding.

  5. 05

    Apply chosen stain whole-room

    Edge-in by hand, field by applicator, wiped back to consistency.

  6. 06

    Seal & finish

    After full dwell and dry, three coats of compatible finish protect the color.

What it costs

Custom Staining pricing in Wrentham, MA.

Custom Staining in Wrentham starts at $1.75/sq ft* for labor. That figure is a starting rate for straightforward work in good-condition rooms; final pricing always depends on square footage, subfloor condition, species and grade selection, finish system, and how much furniture or trim work needs to be moved or scribed around. For context, here are the starting labor rates on the rest of our service lines so you can plan budget across a whole-house project: solid hardwood install from $10/sq ft, refinishing and sanding from $4/sq ft, custom staining from $1.75/sq ft on top of refinish, pre-finished plank install from $5/sq ft, engineered hardwood over slab from $10/sq ft (adhesive runs roughly $4/sq ft on top), and luxury vinyl plank from $6/sq ft.

Material is always quoted separately. Species (red oak versus white oak versus walnut), board width (2 1/4" strip versus 7" wide plank), grade (select versus character), and finish (oil-based polyurethane versus water-based versus hardwax oil) all move the material number. A 1,000 sq ft room in Wrentham can run anywhere from $4,000 in select red oak strip to $18,000 in wide-plank European white oak, depending on those choices. We bring physical samples to the estimate so you see and feel the difference before committing.

No hidden line items. Drive time from North Easton to Wrentham is built into the per-square-foot rate, not added as a separate charge. Dust containment is included. Three-coat finish is standard, not an upcharge. Furniture moving and protection within the work zone is included. The only items quoted on top of the labor-and-material base are: subfloor repair if we find rot or deflection, stair treads, custom stain blends beyond a single tone, and any moldings or transitions we need to fabricate rather than buy stock.

Norfolk County housing context

What Wrentham subfloors and existing floors typically look like.

Wrentham housing stock: New construction colonials, larger square footage. That single data point shapes nearly every decision we make on a Wrentham job, from acclimation time to nail spacing to finish chemistry. A 1920s Wrentham colonial behaves differently under our sander than a 2010 build in a south shore subdivision, and we adjust technique accordingly rather than running every floor through the same process.

Subfloor patterns we see in Wrentham: in pre-1960 homes we routinely find original 3/4" pine plank subfloor with hardwood nailed directly to it; in post-war ranches and capes we find 1/2" plywood, sometimes overlaid on top of older pine; in newer builds we find 3/4" tongue-and-groove OSB or plywood, occasionally with engineered I-joists below. Each of these calls for different fastener length and spacing, different moisture-content tolerances during acclimation, and a different read on whether the subfloor needs screwing-down before any new flooring goes over it. We test moisture content with a probe meter at every job, no exceptions, because cupping and buckling are almost always a subfloor moisture story rather than a wood-selection story.

Common Wrentham project types we see: uncovering and refinishing original hardwood that's been carpeted-over since the 1970s; matching new wide-plank install into an existing room of older strip oak so the transition reads invisible; spot-replacing boards damaged by dishwasher or refrigerator leaks; full-house refinishing on inherited family homes that haven't seen a sander in 25 to 40 years; new installs in kitchen renovations where tile or vinyl is coming out. We come at every one of these the same way: look at the subfloor and the existing material first, decide species and width second, decide finish system third.

Timeline in Wrentham

From the first call to walking on your new floor.

  1. Day 0

    Your call

    Reach us at (508) 962-1962 or through the quote form. We confirm the scope and schedule an in-home visit in Wrentham, typically within a few business days.

  2. Day 1-5

    On-site estimate

    An owner drives out to Wrentham, measures, checks moisture and subfloor condition, brings physical samples, and answers everything. No deposit required.

  3. Day 5-7

    Written proposal

    Itemized proposal in your inbox inside 48 hours of the visit: labor, material, schedule, completion date, and warranty in plain language.

  4. Day 14-28

    Job starts

    Most Wrentham jobs start 2 to 4 weeks after sign-off. Wood acclimates on-site for 5 to 7 days before any nail goes in, then the work runs to the scheduled completion date.

Reviews

5 stars across the board.

5.0

Every review is from a real Massachusetts homeowner. No paid placements.

"One of the best contractors we have worked with. Tim and Steve's crew produced very high quality hardwood floors throughout the house, delivering a beautiful floor ahead of schedule and on budget."

, Alan H., April 2019 · Solid hardwood install, ~600 sq ft

"Professional crew. Fast installation, and they protected walls and even the smoke detectors from dust. We replaced carpet and you'd never know there used to be carpet there."

, Spero T., November 2018 · Carpet to solid hardwood, ~400 sq ft

FAQ

Common questions.

How much does custom staining cost in Wrentham?

Custom Staining in Wrentham typically starts at $1.75/sq ft*. Final pricing depends on subfloor condition, square footage, species, and finish system. Every estimate is free and itemized in writing.

Can you match an existing room of floors?

Yes. We pull panels from your existing room, color-match by eye and chemistry, and run blend transitions where new and old meet.

How dark can you go on red oak?

Red oak's pink undertone fights very dark stains, you can land near walnut tones, but not true ebony without a wire-brush plus tinted finish system. We'll show you panels so you see this trade-off honestly.

How quickly can you start a project in Wrentham?

From your first call, we typically schedule a free in-home visit in Wrentham inside a few business days, deliver a written itemized proposal within 48 hours of that visit, and start most jobs 2 to 4 weeks later. Wood acclimates on-site for 5 to 7 days before any nail goes in.

Are you insured for work in Wrentham homes?

Yes. $2,000,000 general liability and full workers' compensation. Certificates of insurance furnished on request, including additional-insured endorsements for Wrentham condo associations or property managers that require them.

Do you offer a warranty on custom staining work in Wrentham?

Yes. Written workmanship warranty on every job, plus the finish manufacturer's product warranty on the coating system. If something we did fails, we come back. We answer the phone for years afterward, and we have Wrentham-area references who can speak to that.

Honest expectations for Wrentham

What we will and will not promise on a Wrentham job.

What we will promise: a fixed completion date in writing, owner-led work, three-pass sanding where the service calls for it, three-coat finish where the service calls for it, scribed transitions, daily cleanup, written workmanship warranty, and a phone number staffed by an owner if anything goes wrong in the years after. Free in-home estimate in Wrentham, written itemized proposal in 48 hours. No surprise add-ons that were not in the proposal.

What we will not promise: a price quoted sight-unseen, a finish that matches a 1990s photograph exactly, a refinish on a floor whose wear layer is gone, an install on a subfloor we have not seen, or a schedule that cannot accommodate the wood acclimating to your Wrentham home for the required 5 to 7 days. We will tell you honestly at the in-home visit if what you are asking for is not the right answer and what we recommend instead.

Free estimate

Walk your floors. Quote in 48 hours.

Tell us about the project. Tim or Steve drives out, walks the rooms with you, checks the subfloor, and emails a written line-item proposal within 48 hours. No salesperson, no upsell.

Mon, Sat · 9 AM, 5 PM · No after-hours calls go unanswered for long.

CallFree Quote